ASTM F1733-20 聚酰胺（PA）塑料管和管材的对接热融聚酰胺（PA）塑料配件的标准规范.pdf
文档页数：6文档大小：2.85MB文档格式：pdfThis international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards Guides and Remendations issued by the World Trade Organization Technical Barriers to Trade (TBT)Committee. Designation:F1733-20 An American National Standard INTERNATIONAL Standard Specification for Butt Heat Fusion Polyamide(PA)Plastic Fitting for Polyamide(PA)Plastic Pipe and Tubing' This standard is issued under the fixed designation F1733:the number immediately following the designation indicates the year of original adoption or in the case of revision the year of last revision.A number in parentheses indicates the year of last reapproval.A superscript epsilon (s)indicates an editorial change since the last revision or reapproval. 1.Scope* D4066 Classification System for Nylon Injection and Extru- 1.1 This specification covers polyamide (PA)butt fusion sion Materials (PA) fittings for use with polyamide pipe (IPS and Metric)and D6779 Classification System for and Basis of Specification tubing (CTS).Included are requirements for materialsfor Polyamide Molding and Extrusion Materials (PA) workmanship dimensions marking sustained pressure and F412 Terminology Relating to Plastic Piping Systems burst pressure. F2785 Specification for Polyamide 12 Gas Pressure PipeTubing and Fittings 1.2 The values stated in inch-pound units are to be regarded F2945 Specification for...
本文来自九江凉月投稿，不代表文丁图集立场，如若转载，请注明出处：https://www.2b34.com/blog/191947.html
微信扫一扫 
